Toshiba TOSVERT VF-PS1 Instruction Manual page 23

 Control circuit terminal cover
To wire the control circuit terminal, open the control circuit terminal cover in line with the steps given below.
(A)
Control circuit terminal
Open the control circuit terminal cover.
* To open the cover, lift it with your finger
placed at the
the cover.
 Charge lamp
This lamp is lit when a high voltage remains in the inverter. When removing the main circuit terminal cover or opening the
front cover, be sure to check that this lamp is off and follow the instructions about wiring on page 4.
The mounting position of the charge lamp varies from model to model.
VFPS1-2004PL~2150PM
VFPS1-4007PL~4185PL
This lamp is placed behind the main circuit
terminal cover.
VFPS1-2185PM~2450PM
VFPS1-4220PL~4750PL
Charge lamp
(B)
part on the right side of
VFPS1-2550P~2900P
VFPS1-4900PC~4630KPC
Charge lamp
A-11
(1)
(3)
Remove the terminal, if necessary.
* To do so, open the main circuit terminal
cover, loosen the screws that fix the
terminal, using a (-) screwdriver or torx
(T20H) screwdriver, placed your finger on
part and pull out the terminal.
Charge lamp
E6581386
(2)
1