Memobus/Modbus Configuration - YASKAWA D1000 Series Instruction Manual
Type cimr-du/power regenerative converter 200 v class, three-phase input: 5 to 130 kw/400 v class, three-phase input: 5 to 630 kw
Hide thumbs
Also See for D1000 Series:
- Quick start manual (57 pages) ,
- Technical manual (250 pages) ,
- Quick start manual (79 pages)
Table of Contents
Advertisement
C.1 MEMOBUS/Modbus Configuration
C.1 MEMOBUS/Modbus Configuration
Converter can be controlled from a PLC or other master device via serial communications using the MEMOBUS/Modbus
protocol.
MEMOBUS/Modbus communications can be configured using one master (PLC) and up to 255 slaves. The converter
has slave functionality only, and serial communication is normally initiated from the master and responded to by the
slaves.
The master communicates with the specified slave converter. The address or node for each slave must be set prior so the
master can communicate with the slave at that address. A slave that receives a command from the master will perform the
specified function and send a response back to the master.
Figure C.1
D1000
Master (PLC or other)
Slave (converter)
Figure C.1 Connecting Multiple Converter to a PLC
198
YASKAWA ELECTRIC TOEP C710656 07A YASKAWA Power Regenerative Converter - D1000 Instruction Manual
Advertisement
Chapters
Table of Contents
