Using The Digital Operator - YASKAWA D1000 Series Instruction Manual

4.1 Using the Digital Operator

4.1 Using the Digital Operator
Use the digital operator to enter Run and Stop commands, edit parameters, and display data including fault and alarm
information.
◆ LCD Display
Figure 4.1
No. Name
1 Operation Mode Menus
2 Mode Display Area
3 Ready
4 Data Display
DC Bus Voltage
5 Reference
Assignment
<1>
LO/RE
6
Display
<2>
Function Key 1
7
(F2)
84
1
- MODE -
Volt Ref (OPR)
U1-51= 330V
U1-52= 330V
U1-53= 0.00A
7
Figure 4.1 LCD Display
Table 4.1 Display and Contents
Display
MODE Displayed when in Mode Selection.
MONITR Displayed when in Monitor Mode.
VERIFY Indicates the Verify Menu.
PRMSET Displayed when in Parameter Setting Mode.
SETUP Displayed when in Setup Mode.
DRV Displayed when in Drive Mode.
PRG Displayed when in Programming Mode.
Rdy Indicates the converter is ready to run.
– Displays specific data and operation data.
OPR Displayed when the DC Bus Voltage Reference is assigned to the LCD Operator Option.
AI Displayed when the DC Bus Voltage Reference is assigned to the Analog Input.
Displayed when the DC Bus Voltage Reference is assigned to the MEMOBUS/Modbus
COM
Communication Inputs.
OP Displayed when the DC Bus Voltage Reference is assigned to a Option converter.
RSEQ Displayed when the reference is supplied from a remote source.
LSEQ Displayed when the reference is supplied from the operator keypad.
RREF Displayed when the frequency reference is supplied from a remote source.
LREF Displayed when the frequency reference is supplied from the operator keypad.
HELP
Pressing
F2
←
Pressing
F2
HOME
Pressing
F2
ESC
Pressing
F2
YASKAWA ELECTRIC TOEP C710656 07A YASKAWA Power Regenerative Converter - D1000 Instruction Manual
2 3
DRV Rdy
RSEQ
LREF
8
Content
displays the Help menu.
scrolls the cursor to the left.
returns to the top menu (DC Bus Voltage Reference).
returns to the previous display.
YAI
4
5
6