I.1 Preface - YASKAWA D1000 Series Instruction Manual

i.1 Preface

i.1 Preface
Yaskawa manufactures products used as components in a wide variety of industrial systems and equipment. The selection
and application of Yaskawa products remain the responsibility of the equipment manufacturer or end user. Yaskawa
accepts no responsibility for the way its products are incorporated into the final system design. Under no circumstances
should any Yaskawa product be incorporated into any product or design as the exclusive or sole safety control. Without
exception, all controls should be designed to detect faults dynamically and fail safely under all circumstances. All systems
or equipment designed to incorporate a product manufactured by Yaskawa must be supplied to the end user with
appropriate warnings and instructions as to the safe use and operation of that part. Any warnings provided by Yaskawa
must be promptly provided to the end user. Yaskawa offers an express warranty only as to the quality of its products in
conforming to standards and specifications published in the Yaskawa manual. NO OTHER WARRANTY, EXPRESS OR
IMPLIED, IS OFFERED. Yaskawa assumes no liability for any personal injury, property damage, losses, or claims
arising from misapplication of its products.
This manual is designed to ensure correct and suitable application of D1000-Series regenerative converters. Read this
manual before attempting to install, operate, maintain, or inspect a converter and keep it in a safe, convenient location for
future reference. Be sure you understand all precautions and safety information before attempting application.
◆ Applicable Documentation
The following manuals are available for D1000 series:
YASKAWA D1000 Series
Power Regenerative Converter
DIGITAL OPERATOR JVOP-180 ALM
Instruction Manual (TOEP C710656 07)
F1 F2
LO
ESC
RE
RESET ENTER
RUN STOP
CIMR-AA2A0021FAA
200V 3Phase 5.5kW/3.7kW
S/N:
This guide is packaged together with the product and contains basic information required to install and wire the converter.
WARNING AVERTISSMENT NPJT31470-1
Risk of electric shock. Risque de décharge électrique.
Read manual before installing.
● ● Lire le manuel avant l'installation.
● Wait 5 minutes for capacitor Attendre 5 minutes après la coupure ●
discharge after disconnecting de l'alimentation, pour permettre
power supply. la décharge des condensateurs.
To conform to requirements, Pour répondre aux exigences , s
● make sure to ground the supply ●
assurer que le neutre soit relié
neutral for 400V class. à la terre, pour la série 400V.
● After opening the manual switch ● Après avoir déconnécte la protection
between the drive and motor, entre le driver et le moteur, veuillez
please wait 5 minutes before patienter 5 minutes avain d'effectuer
inspecting, performing une opération de montage ou de
maintenance or wiring the drive. It also gives an fault diagnostics, maintenance, and parameter settings. The purpose of this guide is to prepare the converter
câblage du variateur.
Hot surfaces Surfaces Chaudes
Top and Side surfaces may Dessus et cotés du boitier Peuvent
● become hot. Do not touch. ●
devenir chaud. Ne Pas toucher.
危 険
けが．感電のおそれがあります。
● 据え付け、 運転の前には必ず取扱説明書を読むこと。 ●
● 通電中および電源遮断後5分以内はフロントカバー
● を外さない事。
● ● 400V級インバータの場合は、電源の中性点が接地
されていることを確認すること。( 対応）
● 保守・点検、配線を行う場合は、出力側開閉器を
遮断後5分待って実施してください。
高温注意
for a trial run with an application and for basic operation.
インバータ上部、両側面は高温になります。 ●
● 触らないでください。
◆ Symbols
Note: Indicates a supplement or precaution that does not cause converter damage.
Indicates a term or definition used in this manual.
TERMS TERMS TERMS
◆ Terms and Abbreviations
• Conveter: YASKAWA D1000 Series Power Regenerative Converter
TERMS TERMS TERMS
• Drive: Yaskawa 1000-Series Drive
• BCD: Binary Coded Decimal
• H: Hexadecimal Number Format
• IGBT: Insulated Gate Bipolar Transistor
◆ Trademarks
• MECHATROLINK-I/MECHATROLINK-II are trademarks of MECHATROLINK Members Association (MMA).
• Other companies and product names mentioned in this manual are trademarks of those companies.
10 YASKAWA ELECTRIC TOEP C710656 07A YASKAWA Power Regenerative Converter - D1000 Instruction Manual