Copy Function Related Displays - YASKAWA D1000 Series Instruction Manual

5.5 Copy Function Related Displays

5.5 Copy Function Related Displays
◆ Tasks, Errors, and Troubleshooting
The table below lists the messages and errors that may appear when using the Copy function. When executing the tasks
offered by the Copy function, the operator will indicate the task being performed. When an error occurs, a code appears
on the operator to indicate the error. Note that errors related to the Copy function do not trigger a multifunction output
terminal that has been set up to close when a fault or alarm occurs. To clear an error, simply press any key on the operator
and the error display will disappear.
Table 5.9 lists the corrective action that can be taken when an error occurs.
Note: 1. Whenever using the copy function, the converter should be fully stopped.
2. The converter will not accept a Run command while the Copy function is being executed.
3. Parameters can only be saved to a converter when the voltage class, capacity, control mode, and software version match.
Digital Operator Display
128
Table 5.9 Copy Function Task and Error Displays
CoPy Writing Parameter Settings (flashing)
CPyE Error Writing Data
CSEr Copy Unit Error
dFPS Converter Model Mismatch
End Task Complete
iFEr Communication Error
ndAT Model, Voltage Class, Capacity Mismatch
rdEr Error Reading Data
Reading Parameter Settings (flashing)
rEAd
Voltage Class, Capacity Mismatch
vAEr
vFyE Parameter settings in the converter and those saved to the copy function are not the same
vrFy Comparing Parameter Settings (flashing)
YASKAWA ELECTRIC TOEP C710656 07A YASKAWA Power Regenerative Converter - D1000 Instruction Manual
Error Name