IFM Electronic CR0403 Programming Manual page 43

ifm Programming Manual ecomatmobile
Configurations
>
Set up the target
When creating a new project in CODESYS the target file corresponding to the device must be loaded.
► Select the requested target file in the dialogue window [Target Settings] in the menu
[Configuration].
>
The target file constitutes the interface to the hardware for the programming system.
>
At the same time, several important libraries and the PLC configuration are loaded when selecting
the target.
► If necessary, in the window [Target settings] > tab [Network functionality] > activate [Support
parameter manager] and / or activate [Support network variables].
► If necessary, remove the loaded (3S) libraries or complement them by further (ifm) libraries.
► Always complement the appropriate device library ifm_CR0403_Vxxyyzz.LIB manually!
NOTE
The software versions suitable for the selected target must always be used:
• runtime system (ifm_CR0403_Vxxyyzz.RESX),
• PLC configuration (ifm_CR0403_Vxx.CFG),
• device library (ifm_CR0403_Vxxyyzz.LIB ) and
• the further files.
V version
xx: 00...99 target version number
yy: 00...99 release number
zz: 00...99 patch number
The basic file name (e.g. "CR0403") and the software version number "xx" (e.g. "01") must always
have the same value! Otherwise the device goes to the STOP mode.
The values for "yy" (release number) and "zz" (patch number) do not have to match.
The following files must also be loaded:
• the internal libraries (created in IEC 1131) required for the project,
• the configuration files (*.CFG) and
• the target files (*.TRG).
It may happen that the target system cannot or only partly be programmed with your currently
installed version of CODESYS. In such a case, please contact the technical support department of
electronic gmbh.
BasicController (CR0403) Runtime System V03.02
43
2015-04-01
Set up the programming system
13136
11379
4368
ifm