IFM Electronic CR0403 Programming Manual page 181

ifm Programming Manual ecomatmobile
ifm function elements
>
Parameters of the outputs
Parameter
OUTPUT
CURRENT
RESULT
Possible results for RESULT:
Value
Description
dec | hex
0 00 FB is inactive
1 01 FB execution completed without error – data is valid
2 02 function block is active (action not yet completed)
3 03 function block is active – valid values not yet available
128 80 undervoltage on VBBx
129 81 overvoltage on VBBx
130 82 channel setting is invalid
132 84 mode setting is invalid
136 88 filter setting is invalid
141 8D a wire break was detected
(for binary output, plus switching (BH) with diagnosis)
142 8E a short circuit was detected
(for binary output plus switching (BH) with diagnosis)
145 91 current at the output is too high
(for binary output plus switching (BH) with diagnosis and protection)
BasicController (CR0403) Runtime System V03.02
Data type
BOOL
WORD
BYTE
181
ifm function elements for the device CR0403
Description
TRUE: output is activated
FALSE: output is deactivated
only available for current controlable outputs:
current output current in [mA]
feedback of the function block
(possible messages → following table)
2015-04-01
8081