4Wd Type - Kubota MX5100 Workshop Manual

MX5100, WSM

[2] 4WD TYPE

(1) Bevel Gear Case
(2) Bevel Gear (10T)
(3) Front Axle Case
(4) Differential Yoke Shaft
(5) Spiral Bevel Gear (21T)
(6) Collar
(7) Front Axle Bracket, Front
The front axle of the 4WD is constructed as shown above. Power is transmitted from the transmission through the
propeller shaft (24) and to the bevel pinion shaft (21), then to the spiral bevel gear (5) after that to the differential gear.
The power through the differential is transmitted to the differential yoke shaft (4), and to the bevel gear shaft (15)
in the bevel gear case (1).
The revolution is greatly reduced by the bevel gears (17), (13), then the power is transmitted to the axle (12).
The differential system allows each wheel to rotate at a different speed to make turning easier.
(8) Differential Pinion
(9) Differential Case
(10) Axle Flange
(11) Collar
(12) Axle
(13) Bevel Gear (43T)
(14) Bevel Gear (14T)
(15) Bevel Gear Shaft
(16) Front Gear Case
(17) Bevel Gear (9T)
(18) Differential Side Gear
(19) Pinion Shaft
6-M2
FRONT AXLE
(20) Differential Assembly
(21) Spiral Bevel Pinion Shaft (8T)
(22) Front Bracket, Rear
(23) Coupling
(24) Propeller Shaft
(25) Clutch Housing