Table of Contents

Advertisement

MX5100, WSM

[13] OTHERS

Bleeding Fuel System
IMPORTANT
• Air must be removed :
- When the fuel filter or lines are removed.
- When tank is completely empty.
- After the tractor has not been used for a long period of
time.
1. Fill the fuel tank with fuel, and open the fuel cock (1).
2. Open the air vent cock (2) on the fuel injection pump.
3. Start the engine and run for about 30 seconds, and then stop the
engine.
4. Close the air vent cock.
IMPORTANT
• Always close the air vent cock except for bleeding fuel lines.
Otherwise, engine runs irregularly or stalls frequently.
(1) Fuel Cock
(2) Air Vent Cock
Draining Clutch Housing Water
NOTE
• The tractor is equipped with split pin plug (1) under the
clutch housing.
• After operating in rain, snow or tractor has been washed,
water may get into the clutch housing.
1. Check it by pushing in the split pin (1).
2. If water enters into the clutch housing, remove the plug (1) and
drain the water, then reinstall the plug.
(1) Split Pin (Plug)
G-41
G GENERAL
A : Close
B : Open
W10390260
W10391990

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents