Kubota MX5100 Workshop Manual page 251

MX5100, WSM
Wirings
1. Disconnect the 1P connector (1) for PTO safety switch.
2. Disconnect the 1P connector for hazard light (R.H.), (L.H.) and
remove the wiring (2) (R.H.), (L.H.).
3. Disconnect the 1P connector (3) for shuttle safety switch.
4. Remove the ground cable.
(1) 1P Connector for PTO Safety Switch
(2) Wiring for Hazard Light
Disconnecting Wirings 1
1. Disconnected the fuel sensor lead (2) from the fuel level sensor
and the ground lead (3) from the fuel tank (1).
2. Disconnected the 2P connector (4) and the B terminal lead (?)
from the alternator.
3. Remove the starter B terminal mounting nut (7) and
disconnected the B terminal lead from the starter B terminal.
4. Disconnect the ST terminal lead (6) from the battery ST terminal.
5. Disconnect the engine oil pressure switch lead (8) from the
engine oil pressure switch.
(When reassembling)
Starter B terminal
Tightening torque
mounting nut
(1) Fuel Tank
(2) Fuel Level Sensor Lead
(3) Ground Lead
(4) 2P Connector
3-S33
TRANSMISSION
(3) 1P Connector for Shuttle Safety
Switch
W10165740
7.8 to 9.8 N·m
0.8 to 1.0 kgf·m
5.8 to 7.2 lbf·ft
(5) B Terminal Lead (Alternator)
(6) ST Terminal Lead
(7) B Terminal Lead
(8) Engine Oil Pressure Switch Lead
W10395810