Kubota MX5100 Workshop Manual page 293

MX5100, WSM
Brake Case
1. Remove the brake case mounting screws and nuts.
2. Separate the brake case, tapping the brake case lever lightly.
(When reassembling)
• Apply grease to the brake ball seats.
excessively.)
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
face of the brake case and transmission case, after eliminate the
water, oil and stuck liquid gasket.
• Before installing the brake case to the transmission case, install
the cam plate to the transmission case.
• Place the brake discs (6) so that the hole "A" of brake discs
should be overlapped 50 % or more.
Brake case mounting stud
bolt
Brake case mounting
Tightening torque
screw and nut
Brake case lever mounting
screw
(1) Brake Case Mounting Screw
(2) Brake Case
(3) Brake Shaft
(4) Steel Ball
Brake Cam and Brake Cam Lever
1. Remove the brake cam mounting nut and remove the brake cam
(2) and brake cam lever (4).
(When reassembling)
• Apply grease to the O-ring (3) and take care not damage the O-
ring.
(1) Brake Case
(2) Brake Cam
5-S7
BRAKES
(Do not grease
38.2 to 45.1 N·m
3.9 to 4.6 kgf·m
28.2 to 33.3 lbf·ft
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.1 to 66.5 lbf·ft
62.8 to 72.5 N·m
6.4 to 7.4 kgf·m
46.3 to 53.5 lbf·ft
(5) Brake Cam plate
(6) Brake Disc
(7) Plate
W10139950
(3) O-ring
(4) Brake Cam Lever
W10143460