Kubota MX5100 Workshop Manual page 276

MX5100, WSM
Rear Axle Case
1. Place the disassembling stand under the rear axle case.
2. Remove the rear axle mounting screws and nuts.
3. Separate the rear axle case from brake case.
(When reassembling)
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
face of the rear axle case and brake case, after eliminate the
water, oil and stuck liquid gasket.
Rear axle case
Tightening
mounting screw and
torque
nut
4-S4
REAR AXLE
48.1 to 55.9 N·m
M10
4.9 to 5.7 kgf·m
screws
35.4 to 41.2 lbf·ft
60.8 to 70.5 N·m
M10
6.2 to 7.2 kgf·m
nuts
44.9 to 52.1 lbf·ft
M12 77.5 to 90.2 N·m
screws 7.9 to 9.2 kgf·m
and nuts 57.1 to 66.5 lbf·ft
24.5 to 31.4 N·m
Stud
2.5 to 3.2 kgf·m
bolts
18.1 to 23.1 lbf·ft
W10113490