Kubota MX5100 Workshop Manual page 262

MX5100, WSM
Spiral Bevel Gear Turning Torque
NOTE
• It is necessary to adjust the spiral bevel gear turning torque,
when replacing the differential gears, transmission case or
other relative parts.
1. Assemble the differential gears to transmission case. At this
time, install the some shims (3) to the spiral bevel gear side.
2. Check the turning torque by using turning torque tool (1).
Turning Torque Tool : Weld socket on the brake shaft
3. Add or reduce the thickness of shims (3) to make the specified
turning torque.
4. After getting the specified turning torque, divide the thickness of
shims to left and right side.
5. Assemble the transmission case and adjust the backlash and
tooth contact with spiral bevel pinion. (See next page.)
Turning torque of 37T
Factory spec.
spiral bevel gear
(1) Turning Torque Tool
(2) 37T Spiral Bevel Gear
3-S44
TRANSMISSION
(Brake shaft Part No. TA040-26710)
3.92 to 6.37 N·m
0.40 to 0.65 kgf·m
2.89 to 4.70 lbf·ft
(3) Adjusting Shim
(4) Differential Support
W10277520