Kubota MX5100 Workshop Manual page 38

MX5100, WSM
Replacing Engine Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before changing the oil filter
cartridge.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the oil filter.
2. Place a oil pan under the engine oil filter cartridge. Put a film of
clean engine oil on the rubber seal of the new filter.
3. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand a additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil normally
decreases a little. Make sure that the engine oil does not leak
through the seal and be sure to check the oil level on the dipstick.
Then, replenish the engine oil up to the prescribed level.
IMPORTANT
• To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
(1) Engine Oil Filter Cartridge
Replacing Hydraulic Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before changing the oil filter
cartridge.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the drain plugs at the bottom of the transmission case
and drain the oil completely into the oil pan.
2. After draining reinstall the drain plugs.
3. Remove the oil filter.
4. Wipe off metal fillings from the magnetic filter with a clean rag.
5. Quickly tighten the filter until it contacts the mounting surface,
then tighten it by hand an additional 1/2 turn only.
6. After the new filter has been replaced, fill with oil up to the upper
line of the gauge.
Oil capacity
7. After running the engine for a few minutes, stop the engine and
check the oil level again, add oil to the prescribed level.
8. Make sure that the transmission fluid does not leak past the seal
on the filter.
IMPORTANT
• To prevent serious damage to the hydraulic system. Use
only a KUBOTA genuine filter.
• Do not operate the tractor immediately after changing the
transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
(1) Drain Plugs
(2) Hydraulic Oil Filter
(3) Magnetic Filter (Wipe off Metal
Fillings)
(4) Gauge
(5) Oil Inlet
G-20
G GENERAL
W10148920
44.0 L
11.6 U.S.gals
9.7 Imp.gals
(A) Oil level is acceptable within this
range.
W10155860