Kubota MX5100 Workshop Manual page 200

MX5100, WSM
Clutch Case
1. Remove the internal snap ring (1).
2. Remove the external snap ring (2).
3. Remove the clutch case (7) and brake disc (5).
(When reassembling)
• Direct the contact part of the brake disc (5) to the brake plate (6).
• Apply small amount of the grease to the seal rings (8).
(1) Internal Snap Ring
(2) External Snap Ring
(3) Clutch Holder
(4) Collar
Brake Plate
1. Remove the brake plate mounting screws (3) and then take out
the brake plate (4) and the springs (2).
(When reassembling)
• Apply liquid lock (Three Bond 1372 or equivalent) to the brake
plate mounting screws (3).
Brake plate mounting
Tightening torque
screw
(1) Clutch Case
(2) Spring
Piston
1. Press the washer (6) lightly by the hand press, using the hand
made jig. (Refer to the figure left.)
2. Draw out the piston (4).
(When reassembling)
• Apply enough transmission fluid to seal rings (3) and (8).
(1) Clutch Case
(2) Jig
(3) Seal Ring
(4) Piston
(5) Spring
2-S24
CLUTCH
(5) Brake Disc
(6) Brake Plate
(7) Clutch Case
(8) Seal Ring
W10164510
9.8 to 11.3 N·m
1.00 to 1.15 kgf·m
7.2 to 8.3 lbf·ft
(3) Brake Plate Mounting Screw
(4) Brake Plate
W10167880
(6) Washer
(7) External Snap Ring
(8) Seal Ring
A : 41 mm (1.6 in.)
W10169240