Kubota MX5100 Workshop Manual page 140

MX5100, WSM
Fuel Camshaft and Fork Lever Assembly
1. Remove the fuel feed pump.
2. Detach the fuel camshaft stopper (1).
3. Remove the three fork lever holder mounting screws (2).
4. Draw out the fuel camshaft assembly (5), (6) and fork lever
assembly (3), (4), (7) at the same time.
(When reassembling)
• After installation, check to see that the fork lever 1 (3) and lever
2 (4) are fixed to the fork lever shaft, and that they can turn
smoothly in the holder (7).
(1) Fuel Camshaft Stopper
(2) Fork Lever Holder Mounting Screws
(3) Fork Lever 1
(4) Fork Lever 2
Oil Pump
1. Remove the nut.
2. Draw out the oil pump drive gear (2) with gear puller (1).
3. Remove the four oil pump mounting screws. Detach the oil pump
(3).
(1) Gear Puller
(2) Oil Pump Drive Gear
Crank Gear
1. Draw out the crank gear (2) with a puller (1).
2. Remove the feather key.
(1) Crank Puller
1-S48
ENGINE
(5) Injection Pump Gear
(6) Fuel Camshaft
(7) Fork Lever Holder
W1025309
(3) Oil Pump
W1025581
(2) Crank Gear
W1025476