Disassembling And Assembling; Separating Front Axle - Kubota MX5100 Workshop Manual

MX5100, WSM

[2] DISASSEMBLING AND ASSEMBLING

(1) Separating Front Axle

Draining Front Axle Case Oil (4WD Model Only)
1. Place oil pans underneath the front axle case.
2. Remove the drain plug (1) both sides and filling port plug (2) to
drain the oil.
3. After filling, reinstall the drain plugs (1) and filling port plug (2).
(When reassembling)
• Remove the filling port plug (2).
• Fill with the new oil.
• After filling, reinstall the filling port plug (2).
Capacity Front axle case oil
IMPORTANT
• Use KUBOTA SUPER UDT fluid or SAE80, 90 gear oil.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-8.)
(1) Drain Plug
Propeller Shaft (4WD Only)
1. Slide the propeller shaft cover (4) and (8) after removing the
screws (7).
2. Tap out the spring pins (2), (6) and slide the couplings (1), (5) and
then remove the propeller shaft with covers (4), (8).
(When reassembling)
• Apply grease to the splines of the propeller shaft 1 (3).
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft 1
(4) Propeller Shaft Cover
6-S8
FRONT AXLE
7.0 L
7.4 U.S.qts
6.2 Imp.qts
(2) Filling Port Plug
W10128890
(5) Coupling
(6) Spring Pin
(7) Screw
(8) Propeller Shaft Cover
W10132710