Kubota MX5100 Workshop Manual page 319

MX5100, WSM
Axle
1. Remove the bearing with a special use puller set (Code No.
07916-09032).
2. Take out the bevel gear (2).
3. Take out the collar (1).
4. Tap out the axle (3).
(When reassembling)
• Install the oil seal (5) of axle flange (4), noting its direction as
shown in the figure below.
(1) Collar
(2) Bevel Gear
(3) Axle
Steering Cylinder
1. Remove the tie-rod joint (1) (right side).
2. Remove the cylinder set screw (3).
3. Remove the nipples (2) from steering cylinder.
4. Remove the internal snap ring (4).
5. Draw out the steering cylinder (5).
(When reassembling)
• Apply liquid lock (Three Bond 1372 or equivalent) to the tie-rod
joint.
Tie-rod joint and steering
Tightening torque
cylinder mounting screw
(1) Tie-rod Joint
(2) Nipple
(3) Cylinder Set Screw
6-S13
FRONT AXLE
(4) Axle Flange
(5) Oil Seal
W10163910
166.7 to 196.1 N·m
17.0 to 20.0 kgf·m
122.9 to 144.6 lbf·ft
(4) Internal Snap Ring
(5) Steering Cylinder
W10165600