Kubota MX5100 Workshop Manual page 202

MX5100, WSM
Pressure Plate Flatness
1. Place a straight edge on the pressure plate and measure
clearance with a feeler gauge at several points.
2. If the clearance exceeds the allowable limit, replace it.
3. When the pressure plate is worn around its outside and its inside
surface only is in contact with the straight edge, replace even if
the clearance is within the allowable limit.
Clearance between
pressure plate and Allowable limit
straight edge
A : Inside
2-S26
CLUTCH
0.2 mm
0.008 in.
B : Outside
W10176100