MX5100, WSM
[2] DISASSEMBLING AND ASSEMBLING
(1) Starter
Disassembling Motor
1. Disconnect the connecting lead (9) from the magnet switch (8).
2. Remove the screws (6), and then separate the end frame (4),
yoke (2) and armature (1).
3. Remove the two screws (5), and then take out the brush holder
(3) from the end frame (4).
(When reassembling)
• Apply grease to the spline teeth A of the armature (1).
(1) Armature
(2) Yoke
(3) Brush Holder
(4) End Frame
(5) Screw
(6) Screw
Disassembling Magnet Switch
1. Remove the drive end frame (1) mounting screws.
2. Take out the overrunning clutch (2), ball (3), spring (4), gears (5),
rollers (6) and retainer (7).
(When reassembling)
• Apply grease to the gear teeth of the gears (5) and overrunning
clutch (2), and ball (3).
(1) Drive End Frame
(2) Overrunning Clutch
(3) Ball
(4) Spring
Plunger
1. Remove the end cover (1).
2. Take out the plunger (2)
(1) End Cover
9-S26
ELECTRICAL SYSTEM
(7) Nut
(8) Magnet Switch
(9) Connecting Lead
A: Spline Teeth
W1128720
(5) Gear
(6) Roller
(7) Retainer
W1129998
(2) Plunger
W1030398