Kubota MX5100 Workshop Manual page 193

MX5100, WSM
Removing Release Holder and Clutch Lever
1. Draw out the clutch release hub (4) and the release bearing (5)
as a unit.
2. Remove the release fork setting screws (2).
3. Draw out the clutch lever (3) to remove the release fork (1).
(When reassembling)
• Make sure the direction of the release fork (1) is correct.
• Inject grease to the release hub (4).
• Be sure to set the snap pins (6) on both sides.
Release fork setting
Tightening torque
screws
(1) Release Fork
(2) Setting Screw
(3) Clutch Lever
2-S17
CLUTCH
23.5 to 27.5 N·m
2.4 to 2.8 kgf·m
17.4 to 20.3 lbf·ft
(4) Release Hub
(5) Release Bearing
(6) Snap Pin
W1017279