Kyocera FS-C8500DN Service Manual page 78

2KA
Maintenance
item No.
Setting the transfer cleaning voltage
U107
Description
Sets the cleaning control voltage for transfer belt unit.
Purpose
Change settings if an offset has occurred due to the failure of cleaning the transfer belt.
Method
1. Press the OK key.
2. Select an item to be set.
3. Press the OK key. The screen for setting each item is displayed.
Display
Belt Clean A (F)
Belt Clean A (H)
Belt Clean A B/W
Belt Clean B
Setting: [Belt Clean A (F)]
1. Select an item to be set.
2. Change the value using the Left/Right Select keys.
Display
[W]<160
160<=[W]<220
220<=[W]
3. Press the OK key. The value is set.
Setting: [Belt Clean A (H)]
1. Select an item to be set.
2. Change the value using the Left/Right Select keys.
Display
[W]<160
160<=[W]<220
220<=[W]
3. Press the OK key. The value is set.
Setting: [Belt Clean A B/W]
1. Select an item to be set.
2. Change the value using the Left/Right Select keys.
Display
[W]<160
160<=[W]<220
220<=[W]
3. Press the OK key. The value is set.
1-3-42
Description
Description
Transfer belt cleaning voltage (printing)
Transfer belt cleaning voltage (using thick paper)
Transfer belt cleaning voltage in black/white mode
Transfer belt cleaning voltage (paper interval)
Description
Small sizes (under 160 mm wide)
Medium sizes (160 to under 220 mm
wide)
Large sizes (more than 220 mm wide)
Description
Small sizes (under 160 mm wide)
Medium sizes (160 to under 220 mm
wide)
Large sizes (more than 220 mm wide)
Description
Small sizes (under 160 mm wide)
Medium sizes (160 to under 220 mm
wide)
Large sizes (more than 220 mm wide)
Setting range Initial setting
0 to 255 93
0 to 255 93
0 to 255 93
Setting range Initial setting
0 to 255 62
0 to 255 62
0 to 255 62
Setting range Initial setting
0 to 255 120
0 to 255 120
0 to 255 120