Kyocera FS-C8500DN Service Manual page 122

2KA-2
Maintenance
item No.
Setting: [Calib Tmg Prt]
U464
1. Change the setting value using the Left/Right Select keys.
Display
Timing(Sec)
2. Press the OK key. The value is set.
Setting: [Calib Drv Time]
1. Change the setting value using the Left/Right Select keys.
Display
Time(Sec)
2. Press the OK key. The value is set.
Setting: [Calib Prt Rate]
1. Change the setting value using the Left/Right Select keys.
Display
Threshold Lv
2. Press the OK key. The value is set.
Setting: [Custom]
1. Select On or Off.
Display
Off
On
Initial setting: Off
2. Press the OK key. The setting is set.
Setting: [AC Calib]
1. Select the color of the replaced developing unit or drum unit.
Display
Cyan
Magenta
Yellow
Black
High Altitude
2. Select [On] using the Left/Right Select keys.
If the machine is installed at high altitude, select [High Altitude].
3. Press the OK key.
4. Select [Execute].
5. Press the OK key. AC calibration is executed.
6. When normally completed, [Complete] is displayed.
When an error occurs, an error code is displayed.
7. Turn the main power switch off and on.
1-3-86
Description
Setting the drive standard time of contin-
uous print
Description
Setting the drive standard time
Description
Setting the standard printing ratio
Description
Set to custom settings in setting the calibration cycle under the menu mode
Set to standard settings in setting the calibration cycle under the menu mode
Description
Developing unit C or drum unit C
Developing unit M or drum unit M
Developing unit Y or drum unit Y
Developing unit K or drum unit K
Overall setting for installation at high altitude
Description
Setting range
300 to 3600 (s) 1800
Setting range
300 to 3000 (s) 600
Setting range
0 to 100 (%)
Initial setting
Initial setting
Initial setting
20