Kyocera FS-C8500DN Service Manual page 256

2KA
(2) Detaching and refitting the hard disk unit
Follow the procedure below to replace the hard disk unit.
Procedure
1. Perform maintenance mode U917 (backup
data reading) (see page 1-3-99).
2. Remove the rear middle cover (see page 1-
5-11).
3. Remove the cable clamps.
4. Pressing the lock lever and remove the con-
nector.
5. Remove the connector.
6. Release the wire saddle and then remove
the wire.
7. Remove two screws.
1-5-34
Connector
Lock lever
Connector
Figure 1-5-58
Screw
Wire saddle
Wire
Figure 1-5-59
Cable clamp
Cable clamp
Screw
Connector