Kyocera FS-C8500DN Service Manual page 120

2KA
Maintenance
item No.
Setting the ID correction operation
U464
Description
Turns ID correction (calibration) on or off. Also, this determines the duration of calibration and the timing of
calibration during printing. Also, this allows individual settings for calibration operation by enabling custom set-
tings.
Purpose
To restrict calibration when poor image quality is generated. Also, this allows individual settings for calibration
by enabling custom settings in setting the calibration cycle under the machine defaults depending on the user
preferences.
Performs AC calibration when replacing the developing or drum unit.
Method
1. Press the OK key.
2. Select the item to be set.
3. Press the OK key. The setting screen for the selected item is displayed.
Display
Permit
Time Interval
Slp Period Calib
Permit Act(50pp)
Permit(On/SlpOut)
Permit(AP/NE)
Calib Tmg Prt
Calib Drv Time
Calib Prt Rate
Custom
AC Calib
Target Value
AC Calib Mag
Calib Prt Rate(H)
Calib Tmg Prt(H)
AC Calib Type
Prt Rate B/W
1-3-84
Description
Description
Setting to turn calibration on/off
Setting the interval time of calibration after printing
Setting the standard time for judging whether or not to carry out calibration
based on the sleep time when the machine recovers from the sleep mode.
Turning paper interval calibration on/off after continuously printing 50 pages
Setting execution parameters for calibration when powered up or reverted
from auto-sleep
Paper interval calibration ON/OFF setting at the time of calibration/near end
after toner feed
Setting the standard time for judging whether or not to carry out calibration
based on the continuous print driving time during printing.
Setting the standard time for judging whether or not to carry out paper inter-
val calibration based on the driving time during printing.
Setting the standard printing ratio for judging whether or not to carry out cal-
ibration based on the printing ratio when printing the tenth sheet.
Turning custom settings on/off in setting the calibration cycle under the
menu mode
Executing the AC calibration
Setting the sensor target values for toner thick layer calibration and light
amount calibration
AC calibration target bias value setting
Setting the standard printing ratio for judging whether or not to carry out cal-
ibration based on the printing ratio when printing the tenth sheet (half
speed).
Setting the standard time for judging whether or not to carry out calibration
based on the continuous print driving time during printing (half speed).
Mode setting for AC calibration bias control
Setting the proportion of black/white printing at which black/white calibra-
tion is executed during color printing.