Kyocera FS-C8500DN Service Manual page 66

2KA
Maintenance
item No.
Setting the fuser motor control
U052
Description
Enters the sensor data values described on the supplied sheet provided when the loop sensor is replaced and
performs correction processing for the fuser motor.
Purpose
To perform when replacing the loop sensor or paper conveying unit.
Method
1. Press the OK key.
2. Select the item.
3. Press the OK key. The screen for executing each item is displayed.
Display
Loop Sensor
Loop Sensor Ctrl
Method: [Loop Sensor]
1. Select [Scn Board1].
2. Enter the sensor data value of supplied sheet DATA1 using the
Left/Right Select keys.
3. Select [Scn Board2].
4. Enter the sensor data value of supplied sheet DATA2 using the
Left/Right Select keys.
5. Press the OK key. The value is set.
Setting: [Loop Sensor Ctrl]
1. Select the item.
2. Select On or Off.
Display
Top 125mm
Top 250mm
Top 300mm
Top 350mm
3. Press the OK key. The setting is set.
Completion
Press the Back key. The indication for selecting a maintenance item No. appears.
1-3-30
Description
Description
Enter the data value for loop sensor
Set the loop sensor detection control
Description
Sensor detection ON/OFF setting at 125 to 250 mm
from the top of paper
Sensor detection ON/OFF setting at 250 to 290 mm
from the top of paper
Sensor detection ON/OFF setting at 300 to 330 mm
from the top of paper
Sensor detection ON/OFF setting at 350 to 370 mm
from the top of paper
How to read the sensor data value
(e.g.) 1
2
3
4
5
6
7
8
9
0
3 6 4
Initial setting
Off
On
On
On