Kyocera FS-C8500DN Service Manual page 121

Maintenance
item No.
Setting: [Permit]
U464
1. Select On or Off.
Display
Off
On
Initial setting: On
2. Press the OK key. The setting is set.
Setting: [Time Interval]
1. Change the setting value using the Left/Right Select keys.
Display
Count
2. Press the OK key. The value is set.
Setting: [Slp Period Calib]
1. Change the setting value using the Left/Right Select keys.
Display
Time(Min)
2. Press the OK key. The value is set.
Setting: [Permit Act(50pp)]
1. Select On or Off.
Display
Off
On
Initial setting: On
2. Press the OK key. The setting is set.
Setting: [Permit(On/SlpOut)]
1. Select On or Off.
Display
OFF
ON
Initial setting: On
2. Press the OK key. The setting is set.
Setting: [Permit(AP/NE)]
1. Select On or Off.
Display
OFF
ON
Initial setting: On
2. Press the OK key. The setting is set.
Description
Description
Turns calibration OFF
Turns calibration ON
Description
Setting the interval time of calibration
Description
Setting the standard time of sleep mode
Description
Disables permission to execute at continuously 50 pages
Enables permission to execute at continuously 50 pages
Description
Executes calibration regardless of fuser temperature at power-up or
recovery from auto sleep mode
Executes calibration if fuser temperature is less than 50
power-up or recovery from auto sleep mode
Description
Paper interval calibration at the time of calibration/near end after
toner feed is not carried out
Paper interval calibration at the time of calibration/near end after
toner feed is carried out
Setting range Initial setting
0 to 9999 (s) 480
Setting range Initial setting
0 to 480 (min) 60

C/122
2KA

F at
1-3-85