Instructions For The Disposal Of The Packaging Material; Settings For Initial Commissioning By The Service Engineer; Commissioning; Washing With Dish-Washer - Meiko EcoStar 545 D-M Operating Instructions Manual

Operating instructions EcoStar 545 D-M
ATTENTION!
Datei:1_EcoStar545D-M_9654091_Betriebsanleitung_EN_2007-07.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
5.9

Instructions for the disposal of the packaging material

The four-sided wooden frame consists of untreated, raw wood. Special
specific import regulations may also stipulate the use of wood which has been treated
against pests.
The plastic sheeting (PE sheeting) may be recycled.
The cardboard packaging material used to protect the edges can also be recycled.
The steel tensioning strap made of strip steel may be recycled with the steel scrap.
The plastic tensioning strap of plastic (PP) can be recycled.
6 Settings for initial commissioning by the service
engineer
6.1

Commissioning

In order to avoid damage to the installation and the injury and death of persons when
commissioning the installation, the following points must be observed without fail:
Any necessary initial tests to parts supplied by sub-suppliers must be carried out. More
detailed information, if required, can be found in the relevant Instructions for Use.
The installation may only be commissioned by suitably qualified persons
observing the safety instructions.
Before initial startup, check that any tools and parts not belonging to the
installation have been removed.
Check whether any escaping liquid is removed.
Activate all the safety systems and hood switch before commissioning.
Check that all screw connections are tight.
Please also read the chapter on "General safety instructions ".
Commissioning and instructions will be provided by technicians specially trained
by Meiko. The operator may only use the installation after training has been
provided.
7

Washing with dish-washer

The appliance must not be used without a thorough knowledge of the "Operating
Instructions". Incorrect operation could result in injuries to personnel or damage to the
appliance.
7.1

Operating panel

Program is running
appliance is switched on
Temperature display tank / boiler,
Fault display
Information display
Code display
Illustration 1; Operating panel
Update: 2007-07-23
W e reserve the right to change execution and construction!
Program start key
Programme is running
country-
"Off" key
9645091 12/30