Meiko EcoStar 545 D-M Operating Instructions Manual page 23

Operating instructions EcoStar 545 D-M
Datei:1_EcoStar545D-M_9654091_Betriebsanleitung_EN_2007-07.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
Changing the parameters
It is now possible to change the parameter which is currently showing by pressing the
"Accept" button. The two LEDs of the Program Select button will now flash and the
current value will be displayed by the LED combination of boiler and tank temperature.
The 4 LEDs produce a value range of 16 steps as shown in the above mentioned table.
The set value is increased by 1 step by pressing button I and reduced by one step by
pressing button II. When you reach the required value, confirm it by pressing the
"Accept" button. Press the "0" button to leave this setting level without storing the value.
15.2.1 Setting the rinse agent quantity
Press the "Accept" key to confirm that this parameter is to be changed; the two LEDs
of the Program Select buttons will now flash and the current value will be displayed by
the LED combination of boiler and tank temperature. The rinse agent quantity can be
set from 0.03 up to 0.44 ml/l. Increase the value using the "I" key or reduce it using
the "II" key and confirm with the "Accept" key. The two LEDs of the Program Select
buttons will now be permanently illuminated.
You can leave this level by pressing the "0" key.
15.2.2 Setting the detergent quantity
Press the "Accept" key to confirm that this parameter is to be changed; the two LEDs
of the Program Select buttons will now flash and the current value will be displayed by
the LED combination of boiler and tank temperature. The detergent quantity can be
set from 0.36 up to 5.0 ml/l. Increase the value using the "I" key or reduce it using the
"II" key and confirm with the "Accept" key.
The two LEDs of the Program Select buttons will now be permanently illuminated.
You can leave this level by pressing the "0" key.
15.2.3 Adjustment of water hardness
Press the "Accept" key to confirm that this parameter is to be changed; the two LEDs
of the Program Select buttons will now flash and the current value will be displayed by
the LED combination of boiler and tank temperature. The water hardness can be set
from 8 up to 36 °dH. Increase the value using the "I" key or reduce it using the "II" key
and confirm with the "Accept" key.
The two LEDs of the Program Select buttons will now be permanently illuminated.
You can leave this level by pressing the "0" key.
15.2.4 Bleeding program for detergent and rinse agent pipes
The bleeding program is started by pressing the "Accept" key. The LEDs on the tank
and boiler temperature display will flash alternately to indicate that this process is in
progress. The tank temperature display refers to the detergent dosing pump and the
boiler temperature display refers to the rinse agent dosing pump. The dosing pumps
will automatically stop at the end of the pre-defined running times. The two LEDs of
the Program Select buttons will now be permanently illuminated. The bleeding
programme must be carried out twice for appliances with suction from a canister. You
can leave this level prematurely by pressing the "0" key.
Update: 2007-07-23
W e reserve the right to change execution and construction!
9645091 23/30