Installation And Assembly; Floor Load From The Dish-Washing Machine; Instructions For The Disposal Of The Packaging Material - Meiko K-tronic Operating Instructions Manual

Operating Instructions – Dishwashing machine model K-tronic
ATTENTION
Datei:2K_9545483_Betriebsanleitung_EN_1992-01-01.doc
Änderungen in Ausführung und Konstruktion vorbehalten. / W e reserve the right to change execution and construction. / Nous nous reservons le droit de changer l´éxécution et la construction.
MEIKO Maschinenbau GmbH & Co. KG, Englerstr. 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
IMPORTANT!
Horizontal adjustment of the machine by means of the vertically
adjustable feet (spanner/wrench size 27) must be done with
care to ensure that the weight of the machine is evenly
distributed on the cleats.
displacement or stresses caused by loading on one side. These stresses
can cause, for example, the vertical doors to jam or can prevent them from
being water-tight when closed.
•
Please also read the chapter on "General safety instructions".

3.3 Installation and assembly

MEIKO has prepared an assembly diagram showing the machine dimensions and the
connected loads as well as the energy consumption in detail.
Assembly is completed by reference to the assembly diagram and, in general, by
following the instructions of a trained MEIKO engineer.
The installation must
personnel.
We accept no liability for connections carried out by unqualified personnel.
After unpacking, position the appliance as indicated in the assembly diagram and as the
dimensions allow.
The appliance must be level and straight when erected.
If the machine is delivered divided in a number of parts, the joints must be thoroughly
cleaned with acetone and sealed on the inside with silicone (Sista F 103; in paint shops
Terostat 1 S grey). A sealing strip must be applied to the exterior. It should be recessed
by about 1 mm and is also intended to improve the optical appearance.

3.4 Floor load from the dish-washing machine

The floor load per foot (with a loaded surface of D=40 mm per foot) is:
• for dish-washers without a heat pump:
• for dish-washers with a heat pump:

3.5 Instructions for the disposal of the packaging material

•
The four-sided wooden frame consists of untreated, raw pine / spruce.
•
The plastic sheeting (PE sheeting) may be recycled.
•
The cardboard packaging material used to protect the edges can also be
recycled.
•
The steel tensioning strap made of strip steel may be recycled with the steel scrap.
Update: 2012-02-14, S. 16
This is absolutely essential in order to avoid
o n l y be carried out and connected by suitably qualified
approximately 150 kg
approximately 200 kg
An open-ended 27 mm
spanner is needed to
adjust the cleats of the
appliance.
9545483 11/58