Chemicals For The Operation Of The Appliance; Instructions For The Disposal Of The Packaging Material; Settings For Initial Commissioning By The Service Engineer; Commissioning - Meiko FV 40.2 Operating Instructions Manual

Operating instructions FV 40.2 / FV 40.2 G / FV 60.2
IMPORTANT!
IMPORTANT!
Datei:1_FV40_60-2_9546822_Betriebsanleitung_EN_2004-03.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
5.8

Chemicals for the operation of the appliance

Only alkali detergents and acid rinse agents suitable for use in commercial dishwashers
may be used. Corresponding information is submitted by the manufacturers of such
products.
MEIKO recommends brand cleaning products from leading manufacturers. - cleaning
and hygiene products are an excellent choice.
If unsuitable products are used, the life expectancy of the dosing units can be reduced
considerably.
Observe the dosing instructions of the manufacturer.
Detergents and rinse-aids can present a health hazard if they are not correctly used.
Please observe the manufacturers' instructions on the original packing and on the
safety data sheets.
If a de-scaling agent is used, please strictly observe the manufacturer's instructions reg.
handling and safety. After having used such an agent, the product must be completely
removed from the machine, as even small residues are sufficient to destroy plastic parts
and packing materials.
Chemical product settings
The correct settings for the quantity of detergent and rinse agent depend on the
product used.
The relevant chemical supplier can install the correct setting.
5.9

Instructions for the disposal of the packaging material

• The four-sided wooden frame consists of untreated, raw wood. Special
specific import regulations may also stipulate the use of wood which has been treated
against pests.
• The plastic sheeting (PE sheeting) may be recycled.
• The cardboard packaging material used to protect the edges can also be recycled.
• The steel tensioning strap made of strip steel may be recycled with the steel scrap.
• The plastic tensioning strap of plastic (PP) can be recycled.
6 Settings for initial commissioning by the service
engineer
6.1

Commissioning

In order to avoid damage to the installation and the injury and death of persons when
commissioning the installation, the following points must be observed without fail:
Any necessary initial tests to parts supplied by sub-suppliers must be carried out. More
detailed information, if required, can be found in the relevant Instructions for Use.
•
The installation may only be commissioned by suitably qualified persons
observing the safety instructions.
•
Before initial startup, check that any tools and parts not belonging to the
installation have been removed.
•
Check whether any escaping liquid is removed.
•
Activate all the safety systems and door switches before commissioning.
•
Check that all screw connections are tight.
•
Please also read the chapter on "General safety instructions ".
•
Commissioning and instructions will be provided by technicians specially trained
by Meiko. The operator may only use the installation after training has been
provided.
Update: 2008-03-10
W e reserve the right to change execution and construction!
S. „FV 40 G"
country-
12/42
9544094