Installation And Assembly; Floor Load From The Dish-Washing Machine; Instructions For The Disposal Of The Packaging Material - Meiko K-Tronic Operating Instructions Manual

Operating instructions dishwashing machine model K-Tronic
ATTENTION!
Datei:BA-K-tronic_MIKE_9626212_EN_2005-12-01.doc
MEIKO Maschinenbau GmbH & Co. KG, Englerstraße 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
7.4

Installation and assembly

MEIKO has prepared an assembly diagram showing the machine dimensions and the
connected loads in detail.
Assembly is completed by reference to the assembly diagram and, in general, by following
the instructions of a trained MEIKO engineer.
The installation must o n l y be connected by suitably qualified personnel.
We accept no liability for connections carried out by unqualified personnel.
After unpacking, position the appliance as indicated in the assembly diagram and as the
dimensions allow.
The appliance must be level and straight when erected.
If the machine is delivered divided in a number of parts, the joints must be thoroughly
treated with P819 activator (MEIKO ordering no. 9 503 233) and sealed on the inside with
silicone (Sista F 108 – MEIKO ordering no. 0 870 001 or M509, MEIKO ID no. 9 518 385;
in paint shops Sikaflex 260 – MEIKO ordering no. 0 870 030).
Sista P 819 activator
activator Special Silicon adhesive
order no.
9 503 233
A sealing strip must be applied to the exterior.
It should be recessed by about 1 mm and is intended to improve the optical appearance.
7.5

Floor load from the dish-washing machine

The floor load per foot (with a loaded surface of D=30 mm per foot) is:

for dish-washers without a heat pump:

for dish-washers with a heat pump:
7.6

Instructions for the disposal of the packaging material


The four-sided wooden frame consists of untreated, raw pine / spruce.

The plastic sheeting (PE sheeting) may be recycled.

The cardboard packaging material used to protect the edges can also be recycled.

The steel tensioning strap made of strip steel may be recycled with the steel scrap.

The plastic tensioning strap of plastic (PP) can be recycled.
W e reserv e the right to change execution and construction !
Sista F 108
Special Silicon adhesive
order no.
0 870 001
approximately 150 kg
approximately 200 kg
.
Sista M 509 Sikaflex - 260
strong adhesive
order no.
9 518 385 0 870 030
9626212
order no.
19/44