Requirements For The Fresh Water Connection; Requirements For The Waste Water Connection; Emergency-Off; Chemicals For The Operation Of The Appliance - Meiko EcoStar 545 D-M Operating Instructions Manual

Operating instructions EcoStar 545 D-M
ATTENTION!
ATTENTION!
Datei:1_EcoStar545D-M_9654091_Betriebsanleitung_EN_2007-07.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
5.5

Requirements for the fresh water connection

Each appliance carries the DVGW test symbol and does not require an extra safety
valve in the water feed.
Fresh water connection must be made according to EN 1717 or according to
local regulations.
The minimum flow pressure of the clean water supply upstream of the solenoid
valve must be 0.6 bar and if water-softening equipment (EW 10) is incorporated
into the machine: 3 bar.
The maximum pressure must not exceed 5 bar.
If the flow pressure is below the minimum, increase the flow pressure with a
booster pump; if the maximum pressure is exceeded, limit it with a pressure
reducer.
Suitable protective measures must be taken to ensure that no iron particles can
enter the appliance via the mains water supply. Similarly, precautions must be
taken to prevent the entry of other metal particles, for example copper turnings.
Corresponding instructions are contained in the installation drawing. Therefore
suitable measures must be taken.
A dirt trap must be fitted into the fresh water supply to protect the solenoid valve.
5.6

Requirements for the waste water connection

Build an odour trap into the waste water connection if this is not already built-in
(further information about this is in the Installation drawing / Technical Sheet).
A grease trap may be needed, depending on the machine application.
5.7

Emergency-off

Set the local main switch to „OFF" or switch off the local main fuse.
5.8

Chemicals for the operation of the appliance

Only alkali detergents and acid rinse agents suitable for use in commercial
dishwashers may be used. Corresponding information is submitted by the
manufacturers of such products.
MEIKO recommends brand cleaning products from leading manufacturers.
- cleaning and hygiene products are an excellent choice.
If unsuitable products are used, the life expectancy of the dosing units can be
reduced considerably.
Observe the dosing instructions of the manufacturer.
Detergents and rinse-aids can present a health hazard if they are not correctly used.
Please observe the manufacturers' instructions on the original packing and on the
safety data sheets.
After having used such an agent, the product must be completely removed from the
machine, as even small residues are sufficient to destroy plastic parts and packing
materials. If a de-scaling agent is used, please strictly observe the manufacturer's
instructions reg. handling and safety.
Chemical product settings
The correct settings for the quantity of detergent and rinse agent depend on the
product used.
The relevant chemical supplier can install the correct setting.
Update: 2007-07-23
W e reserve the right to change execution and construction!
9645091 11/30