Automatic Dosing; Operation During Washing And Rinsing Cycle - Meiko EcoStar 545 D-M Operating Instructions Manual

Operating instructions EcoStar 545 D-M
ATTENTION!
Program start key
Datei:1_EcoStar545D-M_9654091_Betriebsanleitung_EN_2007-07.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
7.4

Automatic dosing

The required detergent (detergent dosing pump: option) and rinse aid is transported out
of the containers into the tank, resp. boiler, via electronically controlled dosing units. The
dosing is effected automatically acc. to the requirements arising during the wash process.
If unsuitable products are used, the life of the dosing equipment will be significantly
shortened.
We therefore recommend that detergents should have a pH value greater than 7 and
that rinse agents should have a pH value between 7 and 2.
7.5

Operation during washing and rinsing cycle

The following fundamental principles must be observed when placing the items to be
washed in the baskets:
All hollow containers must always to be loaded upside down. Otherwise the water
will be trapped inside and they will not dry to a brilliant finish.
Plates, trays and big plates should always stand at a slight angle in the basket with
their inside faces pointing upwards.
When using cutlery baskets, ensure that cutlery is always inserted handle down.
Load the cutlery baskets with a mixture of spoons, knives and forks, as identical
items of cutlery can be too close together.
Do not overload the baskets.
Do not stack the dishes in the wash basket, as the wash water could not strike the
items directly and the wash times would have to be unnecessarily prolonged. Short
wash times with baskets which are not overloaded are much more economical.
7.5.1 Start the wash cycle
Pre-wash the dishware (major food residues, serviettes, tooth picks, etc.) and
place in the basket.
Place the basket in the appliance, ensuring that it is correctly centred.
Close the hood.
Press the program start key or press down the hood rod.
The appliance washes and rinses automatically and switches off the wash program after
completion. The program cycle is indicated by a light on the program start key.
The wash time can differ from the set program time if the boiler heating capacity is not
sufficient for heating up the fresh water to the pre-set boiler temperature during the
program time. In this case, the automatic wash time extension is activated.
7.5.2 Remove the washed items
When the light goes out, open the hood and remove the basket.
Update: 2007-07-23
W e reserve the right to change execution and construction!
9645091 14/30