Preparation For Washing And Rinsing; Manual Dosing Of Detergent - Meiko EcoStar 545 D-M Operating Instructions Manual

Operating instructions EcoStar 545 D-M
Datei:1_EcoStar545D-M_9654091_Betriebsanleitung_EN_2007-07.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
Key / display
+
Table 1; Program key function / items to be washed
7.2

Preparation for washing and rinsing

The preparatory work described below must be carried out before each operation.
Open the hood.
Place the screen and stand pipe in position.
Close the hood.
Danger of crushing.
Close the appliance with both hands.
Switch on the appliance by pressing one of the program pre-selection keys or press
down the hood rod.
During the filling and heating phase, the light above the pre-selection key will flash.
When the light remains constantly lit, the machine is ready for operation.
The time until the operation readiness is reached depends on the temperature of the
supplied water and the installed boiler, resp. tank heating capacity.
With cold water connection, the duration is about 25 minutes.
7.3

Manual dosing of detergent

If there is no detergent dosing pump, the detergent must be added manually to the
washing water. To obtain a concentration of 2 g/l, an initial amount of 40 g and a later
addition of 30 g after each of 5 cycles should be added.
If the detergent is in powder form, the powder should be scattered evenly on the water in
the tank and dissolved after the tank has been filled. This will prevent discolouration of
stainless steel parts.
Update: 2007-07-23
W e reserve the right to change execution and construction!
Meaning
Short program – Wash programme I
Normal program – Wash program II
Intensive program – Wash program III
Wash temperature
Final rinse temperature
Program start
Tank drain
Self-cleaning cycle
Switch off appliance/
Cycle interruption
9645091 13/30