Installation And Assembly; Dishwasher Floor Loading; Instructions For Disposal Of Packing Material - Meiko KA 15 Operating Instructions Manual

Operating instructions KA 15 / 20 / 30
CAUTION!
File:BA_KA15_9704836_EN_1992-01-01.docx
Änderungen in Ausf ührung und Konst ruktion v orbehalten. / W e reserv e the right t o change execution and const ruction. / Nous no us reserv ons le droit de changer l´éxécution et la construction.
MEIKO Maschinenbau GmbH & Co. KG, Englerstraße 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
Important:
Horizontal adjustment of the machine by means of the vertically adjustable
feet (spanner/wrench size 27) must be done with care to ensure that the
weight of the machine is evenly distributed on the cleats. This is absolutely
necessary to avoid tensions or movements due to one-sided load, as
otherwise the lifting doors could become jammed or cannot be tightly
closed.
 - Read the chapter „General safety rules".
6.3

Installation and assembly

MEIKO has prepared an assembly diagram showing the machine dimensions, the
connected loads and the energy consumption in detail.
Assembly is completed by reference to the assembly diagram and, in general, by
following the instructions of a trained MEIKO engineer.
The machine should o n l y be installed and connected by suitably qualified personnel.
We decline any responsibility for damages caused by incompetent connections.
Unpacked machine components to be placed acc. to the dimensions of the installation
drawing.
The machine must be setup or aligned horizontally.
If the machine is delivered separately in several parts, the separating points must be
treated thoroughly with Aceton and sealed on the inside with silicone (Sista F 103; in
paintshop Terostat 1 S grey). A sealing strip must be applied to the exterior. It should be
recessed by about 1 mm and is intended also to improve the optical appearance.
6.4

Dishwasher floor loading

The floor load per foot (with a loaded surface of D=40 mm per foot) is:
 for dish-washers without a heat pump:
 for dish-washers with a heat pump:
6.5

Instructions for disposal of packing material

 The four-sided wooden frame consists of untreated, raw pine / spruce.
 The plastic sheeting (PE sheeting) may be recycled.
 The cardboard packaging material used to protect the edges can also be recycled.
 The steel tensioning strap made of strip steel can be recycled as scrap metal.
valid from: 2011-03-01
An open-ended 27 mm
spanner is needed to
adjust the cleats!!
approximately 150 kg
approximately 200 kg
Update: 2013-06-17, S. 3-12, 31, 35
9704836 16/58