Requirements For The Waste Water Connection; Emergency-Off; Chemicals For The Operation Of The Appliance; Instructions For The Disposal Of The Packaging Material - Meiko DV 80.2 Operating Instructions Manual

Operating instructions DV 80.2 / DV 120.2 / DV 125.2 / DV 200.2 / DV 200.2 PW
IMPORTANT!
Datei:BA_DV80.2_120.2_125.2_200.2_200.2PW_9625769_EN_2002-10.doc
MEIKO Maschinenbau GmbH & Co. KG, Englerstr. 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
6.6

Requirements for the waste water connection


A waste water pump is integrated in the waste water line. A waste water pump is
integrated in the waste water line (further information about this is in the technical
sheet).

The drain hose must be connected to the waste water pipe in the building.

A grease trap may be needed, depending on the machine application.

The requirements of the waste water supply in the accompanying GiO module
operating and service manual are to be observed for machines equipped with the
GiO module.
6.7

Emergency-off


Switch the machine off completely via the on-site power disconnection device.
6.8

Chemicals for the operation of the appliance

Only alkali detergents and acid rinse agents suitable for use in commercial dishwashers
may be used. Corresponding information is submitted by the manufacturers of such
products.
MEIKO recommends brand cleaning products from leading manufacturers. - cleaning
and hygiene products
If unsuitable products are used, the life expectancy of the dosing units can be reduced
considerably.
Observe the dosing instructions of the manufacturer.
Detergents and rinse-aids can present a health hazard if they are not correctly used.
The manufacturer's instructions on the original packaging and the technical data sheets
must be observed.
"Items for rinsing are tribologically influenced in particular by chemicals and increased
temperatures during the process, as well as mechanical stresses caused by handling
and transporting."
If a de-scaling agent is used, please strictly observe the manufacturer's instructions reg.
handling and safety. After having used such an agent, the product must be completely
removed from the machine, as even small residues are sufficient to destroy plastic parts
and packing materials.
Chemical product settings
The correct settings for the quantity of detergent and rinse agent depend on the
product used. The correct settings for the quantity of detergent and rinse agent depend
on the product used.
The relevant chemical supplier can install the correct setting.
6.9

Instructions for the disposal of the packaging material

 The four-sided wooden frame consists of untreated, raw wood.
Special country-specific import regulations may also stipulate the use of wood which
has been treated against pests.
 The plastic sheeting (PE sheeting) may be recycled.
 The cardboard packaging material used to protect the edges can also be recycled.
 The steel tensioning strap made of strip steel may be recycled with the steel scrap.
 The plastic tensioning strap of plastic (PP) can be recycled.
W e reserv e the right to change execution and construction!
are an excellent choice.
9625769 14/46