Sharp MX-M365N User Manual page 1328

USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ...
PRINTING IS NOT POSSIBLE OR STOPS
DURING A JOB
Is a tray out of paper?
Is the machine out of toner?
Has a paper misfeed occurred?
Is the output tray full?
Is the toner collection container full?
Are restrictions placed on the trays that ca
n be used in each mode (copy, print, fax, Int
ernet fax, and document filing)?
1328 of 1441
Point to check
http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
Solution
Add paper as instructed by the message in the to
uch panel.
Replace the toner cartridge.
When toner runs low, a message will appear to inform y
ou that the toner cartridge must be replaced.
For more information on replacing the toner cartridge,
see "REPLACING THE TONER
Remove the misfeed as instructed by the messag
e in the touch panel.
- "REMOVING MISFEEDS" in "TROUBLESHOOTING"
Remove the output from the tray and resume prin
ting.
When the output tray becomes full, a detector activate
s and stops printing.
Replace the toner collection container as instruc
ted by the message in the touch panel.
- "REPLACING THE TONER COLLECTION CONTAINE
R"
Check the settings in [Paper Tray Settings] and
see if checkmarks appear in the checkboxes of e
ach mode ([Feeding Approved Job]).
Functions without a checkmark cannot be used for pri
nting using that tray.
"Setting mode" → [Paper Tray Settings] → [Tray Reg
istration] → [Feeding Approved Job]
CARTRIDGE".
3/17/2016 7:14 AM