Sharp MX-M365N User Manual page 1112

USER'S MANUAL | MX-M365N/MX-M465N/MX-M565N USER'S ...
destination during broadcasting.
When this setting is enabled, the [Next Address] key cannot be omitted even if the next
address is entered with a one-touch key.
If a user attempts to enter the next address without tapping the [Next Address] key, a
double-beep alarm will sound and the entry will be rejected.
Scan Complete Sound Setting
Sets the scan complete sound to be heard when an original is scanned.
Disable Switching of Display Order
Disables to change the order of display (search number order, ascending, descending).
Once set, the display sequence is not changed. The display order will remain fixed at the
order that is in effect when this setting is enabled.
Hold Setting for Received Data Print
This function holds received faxes and Internet faxes in memory without printing them. The
faxes can be printed by entering a password (factory default setting: 0000) with the
numeric keys.
Password
When [Hold Setting for Received Data Print] is enabled, enter the password (4-digit
number).
Default Verification Stamp
This is used to enable or disable the default setting. Enable this to always affix the
verification stamp on the original that has already been scanned using the automatic
document feeder.
Configure the setting for each of the following items:
E-mail/Scan/Data Entry
Fax/Internet Fax
Erase Width Adjustment
This is used to set the default erase width for erase function. Specify a value from 0" (0
mm) to 1" (25 mm) in increments of 1/8" (3 mm) for both edge erase and center erase.
1112 of 1441
These settings can only be configured when there is no received data in the machine
memory (excluding data in a confidential or relay broadcast memory box).
http://siica.sharpusa.com/portals/0/downloads/Manuals/MX-M365N-M...
3/17/2016 7:14 AM