Connection To X524 Electronics Power Supply - Siemens sinumerik 828d Service Manual

4.17.7

Connection to X524 electronics power supply

Specifications for using the DME20 with UL approval
Pin assignment of the cable for connection to X524:
Pin
1 (brown)
2 (white)
3 (black)
4 (blue)
5 (gray)
The colors stated refer to the cable specified above
1)
Pre-assembled cables
Phoenix Contact (www.phoenixcontact.com)
Sensor/actuator cable, 5-pole, variable cable
Free cable end at the M12-SPEEDCON straight socket
Length of cable: 2, 5, 10, 15 m (up to 100 m on request)
SAC-5P-xxx-186/FS SCO
Cables to be assembled by the user
Cable
Cable ring, PUR/PVC black, 5-pole
Conductor colors: brown/white/blue/black/gray
Length of cable: 100 m
SAC-5P-100.0-186/0.75
order number: 1535590
Phoenix Contact (www.phoenixcontact.com)
Hardware and Software
Service Manual, 03/2011, 6FC5397-5DP40-0BA0
Designation
Electronics power supply
1)
Electronics power supply
1)
Electronics ground
1)
Electronics ground
1)
Not connected internally
1)
Connector
Sensor/actuator connector, socket, straight, 5-pin, M12, A-coded
Screw connection, metal knurl,
Cable gland Pg9
SACC-M12FS-5CON-PG9-M
order number: 1681486
Service cases - hardware
4.17 Hub Modules
Technical specifications
The connection voltage of 20.4 V – 28.8 V
refers to the (terminal) voltage at the
DME20.
This must be observed when selecting the
cable cross-section and supply cable
length:
Pins 1 and 2: jumpered internally

Pins 3 and 4: jumpered internally

207