This Is How You Install An Smc10/Smc20 - Siemens sinumerik 828d Service Manual

Service cases - hardware
4.14 Sensor Modules Cabinet
Procedure:
1. Withdraw the electronics power supply connector X524 and label.
2. Unscrew the encoder connecting cable at X520 or X521 / X531, if required, also the
3. Withdraw the DRIVE-CLiQ cable X500 and write the slot designation on the cable.
4. Release the protective conductor connection and write the position designation on the
5. Push the lug downwards.
6. Swivel the module to the front.
CAUTION
The 50 mm clearances above and below the components must be observed.
4.14.4

This is how you install an SMC10/SMC20

Installing
Procedure:
1. Place the components on the mounting rail.
2. Then, swivel the components on the mounting rail so that the mounting catches click into
3. Slide the components along the mounting rail to either the left or right up to their final
4. Screw on the protective conductor connection.
5. Screw on the encoder connecting cable to X520 and X521 / X531, if required, also the
6. Insert the DRIVE-CLiQ cable at X500.
7. Insert connector X524 for the electronics power supply.
182
shield connection.
cable.
place at the rear.
position.
shield connection.
CAUTION
The 50 mm clearances above and below the components must be observed.
Hardware and Software
Service Manual, 03/2011, 6FC5397-5DP40-0BA0