Motor Module Booksize Compact Format; Motor Module Booksize Compact Status Displays - Siemens sinumerik 828d Service Manual

Service cases - hardware

4.9 Motor Module Booksize Compact format

4.9 Motor Module Booksize Compact format
4.9.1

Motor Module Booksize Compact status displays

Status displays
The Motor Module has the following status displays, which provide information about the
module state:
LED state
RDY DC LINK
OFF OFF
Green ---
Orange
Red
Orange Orange
Red --
Green / Red --
(0.5 Hz)
Green / Red --
(2 Hz)
Green/Orange --
or
Red/Orange
DC link voltage
Hazardous DC link voltages may be present at any time regardless of the state of the
"DC LINK" LED. The warning information on the components must be carefully observed!
144
Description, cause
Electronics power supply is missing or outside
permissible tolerance range.
The component is ready for operation and cyclic
DRIVE-CLiQ communication is taking place.
The component is ready for operation and cyclic
DRIVE-CLiQ communication is taking place.
The DC link voltage is present.
The component is ready for operation and cyclic
DRIVE-CLiQ communication is taking place.
The DC link voltage is too high.
DRIVE-CLiQ communication is being established.
This component has at least one fault.
Note:
The LED is controlled irrespective of the corresponding
messages being reconfigured.
Firmware is being downloaded.
Firmware download has been completed. Wait for
POWER ON.
Component recognition via LED is activated (p0124).
Note:
Both options depend on the LED status when module
recognition is activated via p0124 = 1.
DANGER
Remedy
–-
–-
–-
Check the line supply
voltage.
–-
Remove the fault and
acknowledge
–-
Carry out a POWER ON
–-
Hardware and Software
Service Manual, 03/2011, 6FC5397-5DP40-0BA0