Software Update; This Is How You Update The Software - Siemens sinumerik 828d Service Manual

Hide thumbs Also See for sinumerik 828d:
Table of Contents

Advertisement

Service cases - software

3.4 Software update

3.4
Software update
3.4.1

This is how you update the software

Data backup
If a system update is necessary, then the system data must be backed up so that no data is
lost in the case of a problem.
In this case, we recommend to perform two types of data backup.
1. Generate an image of the system CompactFlash Card ("clone", see also: This is how you
2. Generate an archive for series commissioning (see This is how you generate a series
Note
Backup and archive the data of the control system to an external data carrier before
booting. Observe the information in the update instructions.
Updating the control
Preconditions:
● The control system is switched off.
● The image for the update is saved on the CompactFlash card.
● The CompactFlash card is inserted in the slot on the front panel of the control.
Procedure:
1. Switch-on the control again, as the image can only be generated when booting. After the
44
generate a software backup (Page 36)).
A backup is generated just in case an error occurs during the update. This means that it
is then possible to restore the "old system".
commissioning archive on an external data carrier (Page 27)), in order to restore the
machine-specific data.
The control is booted using a *.tgz file on the storage medium (CompactFlash Card or
USB-FlashDrive) in the slot at the front panel of the control.
control has been switched-on, the following display appears:
Hardware and Software
Service Manual, 03/2011, 6FC5397-5DP40-0BA0

Advertisement

Table of Contents
loading

Table of Contents