4.14.8
This is how you install an SMC30
Installing
Figure 4-42
Procedure:
1. Place the components on the mounting rail.
2. Then, swivel the components on the mounting rail so that the mounting catches click into
3. Slide the components along the mounting rail to either the left or right up to their final
4. Screw on the protective conductor connection.
5. Screw on the encoder connecting cable to X520 or X521 / X531, if required, also the
6. Insert the DRIVE-CLiQ cable at X500.
7. Insert connector X524 for the electronics power supply.
Hardware and Software
Service Manual, 03/2011, 6FC5397-5DP40-0BA0
Installing SMC30
place at the rear.
position.
shield connection.
Service cases - hardware
4.14 Sensor Modules Cabinet
187