Siemens sinumerik 828d Service Manual page 4

Preface
Target group
This document addresses maintenance and service personnel.
Benefits
Based on the Service Manual, the target group can correctly and safely perform service and
maintenance work.
Utilization phase: Maintenance and service phase
Standard version
This documentation only describes the functionality of the standard version. Extensions or
changes made by the machine manufacturer are documented by the machine manufacturer.
Other functions not described in this documentation might be executable in the control. This
does not, however, represent an obligation to supply such functions with a new control or
when servicing.
Further, for the sake of simplicity, this documentation does not contain all detailed
information about all types of the product and cannot cover every conceivable case of
installation, operation or maintenance.
Technical support
Country-specific telephone numbers for technical support are provided in the Internet under
"Contact" (www.siemens.com/automation/service&support).
EC Declaration of Conformity
The EC declaration of conformity for the EMC directive can be found in the Internet
(www.siemens.com/automation/service&support).
Here, enter the number 15257461 as the search term or contact your local Siemens office.
CompactFlash Cards
● The SINUMERIK CNC supports the file systems FAT16 and FAT32 for
● Do not remove the memory card while it is being accessed. This can lead to damage of
4
CompactFlash cards. You may need to format the memory card if you want to use a
memory card from another device or if you want to ensure the compatibility of the
memory card with the SINUMERIK. However, formatting the memory card will
permanently delete all data on it.
the memory card and the SINUMERIK as well as the data on the memory card.
Hardware and Software
Service Manual, 03/2011, 6FC5397-5DP40-0BA0