Advanced Settings; Input/Output (Nmea) Connection; Navigate - Standard Horizon CP500 Owner's Manual

13. ADVANCED SETTINGS

The Advanced Setup menu allows customization of many GPS functions, Alarms and
NMEA interfacing.
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
While in this menu you will see many selections which are described in the next sections.
13.0

INPUT/OUTPUT (NMEA) CONNECTION

The CP500 has 4 NMEA inputs and 5 NMEA outputs. The NMEA outputs can be configured
to send specific NMEA messages.
After a software upgrade the RAM is cleared and then the GPS Chart Plotter starts with the
default settings.
After reset is performed the Input/Out Connections menu must be configured to allow AIS and
FF520 operation.
13.1

NAVIGATE

The Navigate Menu allows customization of the Coordinate System (Loran TD's), Map
Datum, Map Orientation Resolution (angle the vessel has to change before the chart is
redrawn) and Static Navigation. See the following table:
Coordinate System
Map Datum
Map Orientation Resolution: Sets the angle the vessel has to change before the chart is redrawn. The default setting
Static Navigation
The Loran TD selection allows the GPS Chart Plotter to be set up so the user can enter in
LORAN TD's directly into the GPS Chart Plotter. After the TD's have been entered, and the
user changes to ddd mm.sss (Degrees Minutes and Seconds) the TD's will be converted
to Lat / Lon coordinates.
To use the TD Coordinate System the user must setup the Chain and Pair information of
the TD's. If you do not know this information, refer to paper charts that show the Chain and
Pair information.
CP500
NOTE
: Selections are:
a. TD: Loran TD
b. UTM: Universal Transverse Mercator Grid
c. ddd mm.mmm: Degrees Minutes and Thousands of Minutes
d. ddd mm.mm: Degrees Minutes and Hundredths of Minutes
e. ddd mm.ss: Degrees Minutes and Seconds
: Allows selection of Map Datums. The default Datum is WGS84 as C-MAP cartography
has been compiled using the WGS84 Datum.
is 30 degrees. Example: if the vessel is heading 000T at a speed of 25 Knots, the display
will redraw:
a. In Home mode the GPS Chart Plotter centers the location of the vessel in the center
of the display. To keep the vessel in the center of the display the GPS Chart Plotter
will occasionally redraw.
b. If the vessel changes course greater than 330T or more than 30T the chart will be
redrawn.
: Sets up a threshold for the speed. When the speed received from the positioning device
is under that threshold, the GPS Chart Plotter displays zero.
Page 71