Programming And Parameters - Allen-Bradley PowerFlex 525 User Manual

Programming and Parameters

This chapter provides a complete listing and description of the PowerFlex 525
parameters. Parameters are programmed (viewed/edited) using either the drive's
built-in keypad, RSLogix 5000 version 17.0 or greater, Logix Designer version
21.0 or greater, or Connected Components Workbench version 3.0 or greater
software. The Connected Components Workbench software can be used offline
(through USB) to upload parameter configurations to the drive or online
(through Ethernet connection).
Limited functionality is also available when using the Connected Components
Workbench software online (through DSI and serial converter module), a legacy
external HIM, or legacy software online (DriveTools SP™). When using these
methods, the parameter list can only be displayed linearly, and there is no access
to communications option card programming.
For information on...
About Parameters
Parameter Groups
Basic Display Group
Basic Program Group
Terminal Block Group
Communications Group
Logic Group
Advanced Display Group
Advanced Program Group
Network Parameter Group
Modified Parameter Group
Fault and Diagnostic Group
AppView Parameter Groups
CustomView Parameter Group
Parameter Cross Reference by Name
Rockwell Automation Publication February - February 2013
3
Chapter
See page...
58
58
63
68
73
85
91
94
98
118
118
119
126
127
128
57