Configuring An Isatap Tunnel; Figure 16-1 Isatap Tunnel Principle - Zte ZXR10 5900E Configuration Manual

ZXR10 5900E Series Configuration Guide (IPv6)
matched tunnel entity according to the source address and destination address of
the packet. If the matched tunnel entity is found, the IPv4 header encapsulated is
removed, and the left IPv6 packet is handled according to the IPv6 packet receiving
flow.
ISATAP tunnel principle is shown in

Figure 16-1 ISATAP Tunnel Principle

16.2 Configuring an ISATAP Tunnel

To configure an ISATAP tunnel on ZXR10 5900E, perform the following steps:
Step
1
2
3
4
5
6
SJ-20150114102049-011|2015-01-15 (R1.0)
Command
interface v6_tunnel1<tunnel_no>
ZXR10(config)#
ipv6 enable
ZXR10(config-if)#
ipv6 address <addrprefix / prefix-len>
ZXR10(config-if)#
eui-64
ipv6-tunnel-config
ZXR10(config)#
interface v6_tunnel1<tunnel_no>
ZXR10(config)#
ZXR10(config-ipv6-tunnel-if-v6_tunnel1)#
mode ipv6ip isatap
Figure 16-1.
tunnel
16-2
ZTE Proprietary and Confidential
Function
Creates an IPv6 tunnel
interface. Use the no format
of this command to delete a
tunnel interface.
Enables IPv6.
Configures an eui-64 address
on an interface for an ISATAP
tunnel.
Enters IPv6 tunnel
configuration mode.
Enters IPv6 tunnel interface
configuration mode.
Sets the tunnel mode to isatap.
Use the no format of this
command to delete the current
tunnel mode.