Maintaining Bgp4 - Zte ZXR10 5900E Configuration Manual

ZXR10 5900E Series Configuration Guide (IPv6)

9.3 Maintaining BGP4+

Common Maintenance Commands for Viewing Information
Certain debugging commands can be used to locate and remove BGP route faults. The
show command is most commonly used and can be run on a router to show the current
BGP neighbors and the BGP routes learned by the router.
To maintain BGP, run the following commands:
Command
ZXR10(config)#
ZXR10(config)#
ZXR10(config)#
ZXR10(config)#
The following is a sample output from the show ip bgp protocol command:
E1#show ip bgp protocol
BGP router ID is 1.1.1.11, Local as is 100
Hold time is 180 seconds, KeepAlive time is 60 seconds
Default local preference is 100
Default export metric is 0
IPv4 IGP synchronization is disabled
IPv6 IGP synchronization is disabled
Default information advertise is disabled
Always compare med is disabled
Fast fallover is enabled
Client-to-client reflection is enabled
Enforce-first-as is enabled
IPv4 client-number: 1
IPv4 unicast is activated
BGP FRR is disabled
BGP IPv6 frr is disabled
Router target is filtered
Graceful restart is disabled
As-path ignore is disabled
Router-id ignore is disabled
BGP advertise-active-only is disabled
BGP VPNv4 advertise-active-only is disabled
BGP IPv4 rib-only is disabled
SJ-20150114102049-011|2015-01-15 (R1.0)
show ip bgp protocol
show bgp ipv6 unicast neighbor
show bgp ipv6 unicast
show BGP ipv6 unicast summary
9-2
Function
Shows configuration information
about the BGP protocol module.
Shows BGP adjacency and the
current neighbor status.
Shows the entries in the BGP
routing table.
Shows the states of all BGP
neighbors.
ZTE Proprietary and Confidential