Chapter 6 Ripng Configuration; Configuring The Ripng - Zte ZXR10 5900E Configuration Manual

6.2 Configuring the RIPng

RIPng configuration includes the enabling of RIPng and the configuration of RIPng protocol
parameters.
Enabling RIPng
To enable RIPng, perform the following steps.
Step
1
2
3
Configuring RIPng Protocol Parameters
To configure RIPng protocol parameters, perform the following steps.
l
Configure the timers of RIPng:
Step
1
2
The command parameters in step 2 are described as follows:
Parameter
<update>
<timeout>
<garbage>
l Set the default metric of RIPng routes:
SJ-20150114102049-011|2015-01-15 (R1.0)
Command
ipv6 router rip
ZXR10(config)#
interface <interface-name>
ZXR10(config-ripng)#
ZXR10(config-ripng-if)#
Command
ipv6 router rip
ZXR10(config)#
ZXR10(config-ripng)#
><garbage>
ipv6 rip enable
timers basic <update><timeout
Description
Specifies the periodic packet sending interval in the unit
of seconds. The value range is 5-65535 seconds. The
default value is 30 seconds.
Specifies the time for the route to become invalid in the
unit of seconds. The value range is 5-65535 seconds.
The default value is 180 seconds.
Specifies the time period from the time when the route
becomes invalid to the time when the route is deleted in
the unit of seconds. The value range is 5-65535 seconds.
The default value is 120 seconds.
6-3

Chapter 6 RIPng Configuration

Function
Enters the RIPng configuration
mode.
Enters the RIPng interface
configuration mode.
Enables RIPng on an interface.
Function
Enters the RIPng
configuration mode.
Configures the timers of
RIPng.
ZTE Proprietary and Confidential